[. . . ] For Models 7004, 7005, 7006, 7007, 7008 FREDDY FENDERS INSTALLATION INSTRUCTIONS 1 Attach fender to fork using nut and 47 mm bolt. [. . . ] If bridge has no hole or there is no bridge, use 2 zip ties going through channels in plastic clip then tighten around each seat stay. PRECAUTION: Adjust overall position of fender before firmly tightening zip ties. 5 2 Bolt stays to outside of threaded dropout eyelets (lower eyelet if you have two per side) using 14 mm bolts and washers. Slide adjustable stays to conform fender to curvature of tire without rubbing. HARDCORE (7006, 7007, 7008): Adjust stainless steel stays using eyelet bolts/nuts. BASIC (7004, 7005): Adjust stays at dropout eyelets via adjustable slide eyelets. 4 Attach front end of fender to chain stay bridge using preinstalled metal clip. If clip doesn't attach securely, bend it out of the way and use a zip tie going through hole in bottom of fender below clip and around the bridge. [. . . ] PRECAUTION: Make sure attachment bolt does not interfere with cassette/chain. [. . . ]